Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Call JB first and ask. I just sent that same flywheel in to JB to be refreshed because it was out of the car, like yours, and they refused to put a new plate on it and shipped it back.
-
Where did you source your boslters? I have this exact interior I'm trying to revive to swap into hoopty!...
Leave a comment:
-
-
He was showing you that page link, as there is a dropdown for grind option which includes a 284/280, 292, and 304. I have used their 284/280 on a 3.1L build with good success.
Also, it's...
- Likes 1
Leave a comment:
-
Hoopty is done! Header V2 is finished up. Once I'm done spending every waking moment moving shops for the next 3mo, I'm going to do a stock exhaust/header dyno comparison to get some data. The primaries...Last edited by AWDBOB; 03-13-2024, 08:45 AM.
Leave a comment:
-
-
I am his local support 😂
We have tried everything I can think of.
I suspect his initial tach issues with the car that were solved by a fuse 21 issue are relevant to a wiring...
Leave a comment:
-
I have seen so many diffs with incorrect tags, information, you name it- I ALWAYS pull the cover and verify ring gear stamp and carrier stamp when i pull a diff out of a car and mark it before it hits...
Leave a comment:
-
Possible bad K5 relay?
"We can see we are dealing with fuse 17, which has a rating of 30 amps. We can also see in the diagram that fuse 17 is "hot in run only from unloader relay...
Leave a comment:
-
Yeah, you *should* be using the Motronic 1.3 parts with that setup, which will use a front crank trigger at the harmonic balancer, and thus you won't need the bellhousing mounted crank sensors any mo...
Leave a comment:
-
To not use the bellhousing mounted crank sesnor setup you would need to do a full Motronic 1.3 conversion which is its own research topic for you.
The easiest thing to do is just find an...
Leave a comment:
-
I assumed that because you didn't post about the crank sensor holes that you weren't planning on using them haha.
Yeah, you'd need to drill those bosses out and run a flywheel with a reference...
Leave a comment:
-
All m20 g260s will bolt up to all m20s. You just need to match flywheel and TOB to the depth of the bellhousing. The trans you have should be p/n 260.0.1346.90 and thus a shallow bellhousing trans. Will...
Leave a comment:
-
Operation turn my entire backyard into a pole barn is underway
Untitled by Bobbie Morrone, on Flickr
Untitled by Bobbie Morrone, on Flickr
I also made some more...Last edited by AWDBOB; 03-07-2024, 06:55 PM.
- Likes 2
Leave a comment:
No activity results to display
Show More
Leave a comment: