Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I don't remember that much about the IVM except 80% was not applicable, it mainly provides power to the few power hogs (Valvetronic motor & water pump) and that the K-line is supposed to go through...
-
I have both the Bruno steering one from Portugal and the one that Epowersteering gave me. They both have a pot and they function identically.
I'm not at the point of needing Vss because...
- Likes 1
Leave a comment:
-
Driven!
So far, the most accurate thing I could say is "it works". I just went to the bank and back and there were still tools adrift on the passenger floor for serious cornering...
- Likes 1
Leave a comment:
-
-
Yeah, pretty much. I'm guardedly optimistic and believe me, I've been skeptical.
I bought a Vue motor unit just to play with (you should too!) and understand how it works. hubcapboy came...
Leave a comment:
-
yeah, it was designed to fit with ALL of the usual crap under the dash....
- Likes 1
Leave a comment:
-
Thing done.
The output side of the motor unit has a pin that was a pivot in the original GM installations, so lacking a proper mounting flange I fabricated a bracket that uses that pin. 5/8"...
- Likes 1
Leave a comment:
-
Panici There are two vendors for e30 EPAS. EZ Power Steering and Epowersteering. The EZ one is based in Netherlands, I think, and seems to be more comprehensive. You don't need to send them your old shaft...
Leave a comment:
-
yeah, it would be cool if someone figured this out for not so much.
https://www.r3vlimited.com/board/for...ering/10116665...
- Likes 1
Leave a comment:
-
EPAS, or E Power Steering
Starting this thread to document my experimenting with an EPowerSteering.com conversion. This uses the ubiquitous Saturn Vue EPAS column assist unit that's pretty much the standard in the field right...Last edited by hoveringuy; 03-21-2024, 07:44 PM.
-
Need to revive this thread -again- because with electric power steering columns coming on-line this is the natural rack choice....
Leave a comment:
-
I did notice the unit working during light trail braking in the rain; tighter and lower speed corners where I wasn't afraid of losing it, so it does help, but physics is a bitch and if you are hauling...
Leave a comment:
-
First track day of the season, it was cold and clear in the morning and then pissing rain and windy in the afternoon. In other words, a perfect day for testing!
I'm very pleased with the...
Leave a comment:
-
There was just a thread on this. https://www.r3vlimited.com/board/for...-trans-options
- Likes 1
Leave a comment:
-
Beautiful work! The CAD was meant for the bend radius of steel but I guess it works for aluminum, too. Nice!
You'll find the bottom of the pan is even with, or above, the bottom of the...
- Likes 1
Leave a comment:
No activity results to display
Show More
Leave a comment: