Ok. So I have revshift red motor mounts. And they ripped apart on my M10 in two nights if dirt track racing.
We are planing on replacing the whole aluminum arm and poly mint with a custom fabricated mount. Made solid from 1/8 inch plate to the engine and where it matches the subframe. And using a peice of 100 wall 2.5 inch roll bar tubing cut to angle and welded in. We afraid the aluminum will fail when we mint it solid since we already ripped a poly mount apart.
My question is that there is a black support bar running from under the intake manifold down to the mounting point on the block. Has any body done away with this support bar??
We are planing on replacing the whole aluminum arm and poly mint with a custom fabricated mount. Made solid from 1/8 inch plate to the engine and where it matches the subframe. And using a peice of 100 wall 2.5 inch roll bar tubing cut to angle and welded in. We afraid the aluminum will fail when we mint it solid since we already ripped a poly mount apart.
My question is that there is a black support bar running from under the intake manifold down to the mounting point on the block. Has any body done away with this support bar??