Wiring in Map Sensor--(Goathumper?) v3.0 ms2 pnp

[kistler#7]

I am trying to wire in my GM Map sensor--v3.0 ms2 in 55 pin case, pnp built by Goathumper(?). Megamanual says to wire gm map sensors into pin #1 (the square pin) in the map sensor input, thats centered in the pic below


On the other side the wire soldered in:


Which goes across the board and enters the bundle on the bottom side:


Or right side as pictured here:



And into this connector, 5th from the right


And then where? It goes 'underground', do any megasquirt (or motronic?) geeks know where the wire goes, or to which pin in the 55 pin terminal?

[whodwho]

Definitely not one of mine, looks like an old Goathumper one

You should be able to remove the jumper wire for the one that is soldered in(the map sensor must be on the adapter board) and solder your connection as mentioned in the manual

[kistler#7]

Ok thanks for the help. Hopefully next post is a startup vid