Installed my lc1 according to numerous appropriat suggestions on this forum. Jumped the relay etc.
Led installed correctly...
When ignition is powered, the led does its blinking thing fpr avout 15 seconds then goes full solid. At this point o2 heater gets the sensor nice and hot. Air calibration appears to work as it should, but I noticed something strange with the guage.
After ingition is powered the guage sweeps as it should and sits at 0. The led blinks as it should and as soon as it goes solid, the guage jumps to full rich, and the engine isnt even running? This doesnt seem like a normal situation.
I havent configured anything with my computer yet because i cant get my serial adapter to work with win 7. But still.. why would it shoot to full rich with the engine off?
Led installed correctly...
When ignition is powered, the led does its blinking thing fpr avout 15 seconds then goes full solid. At this point o2 heater gets the sensor nice and hot. Air calibration appears to work as it should, but I noticed something strange with the guage.
After ingition is powered the guage sweeps as it should and sits at 0. The led blinks as it should and as soon as it goes solid, the guage jumps to full rich, and the engine isnt even running? This doesnt seem like a normal situation.
I havent configured anything with my computer yet because i cant get my serial adapter to work with win 7. But still.. why would it shoot to full rich with the engine off?
Comment