Hey guys,
Im sorry to bring this topic up again I know its been covered several times but I can't get my f*($*ng driveshaft to lengthen. Before I took the engine out everything hooked up perfect. Now I put everything back together and it seems as though its 3/4 inch too short. It is possible the driveshaft hit floor several times as car was going in and out of shop when engine was out so it could have been tapped in a couple times but nothing crazy. Anyways any advice how to get it to stretch? I completely loosened the center nut and pulled and tapped on it with a hammer and nothing.
Im double guessing myself and thinking if theres some spacer or something I missed but I went over everything 100 times and googled and forum search this over and over and I can't figure it out.
Any advice will help a lot. Thanks!
Im sorry to bring this topic up again I know its been covered several times but I can't get my f*($*ng driveshaft to lengthen. Before I took the engine out everything hooked up perfect. Now I put everything back together and it seems as though its 3/4 inch too short. It is possible the driveshaft hit floor several times as car was going in and out of shop when engine was out so it could have been tapped in a couple times but nothing crazy. Anyways any advice how to get it to stretch? I completely loosened the center nut and pulled and tapped on it with a hammer and nothing.
Im double guessing myself and thinking if theres some spacer or something I missed but I went over everything 100 times and googled and forum search this over and over and I can't figure it out.
Any advice will help a lot. Thanks!
Comment