If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Running the 325E bottom end with the "I" head, and wiring harness, will I need the toothed flywheel from the "I" motor and will I still run the CPS and reference sensor on the "E" transmission?
You'll have better luck searching "harmonic balancer" when your cruising the classifieds. And IIRC there was a free one in an m20 part out thread recently
They can be depending on how you set stuff up. pretty sure whodwho has all his stuff ready to rock so you want to go off of what he recommends. There are different types of trigger wheels you can use for aftermarket applications, diyautotune sells a few. it's all in the programming.
whodwho took out the guess work, real pnp, you just have to play in his parameters.
The megasquirt needs a missing tooth/teeth type of setup like the toothed front balancer on M20B25 which is 60-2.
I'm pretty sure the toothed flywheels don't have missing teeth which is why they have a second reference sensor but i could be wrong. If i'm wrong and the flywheel does have a missing tooth arrangement that is supported by the MS then you should be able to use it.
Comment