1990 BMW 325I M52 Swap E30 HPDE car
1990 BMW 325i Silver on black
Where do I start. . . this car has been so much fun and I have a lot of great memories in it. I'm looking to move on and buy a dedicated race car so this needs to find a new home. I have driven this car to Road Atlanta, Barber, AMP and Roebling Road without a single issue. I have replaced a lot of parts and put a ton of money into it over the past year. It's built right without any cut corners and I always use quality parts. It's been a southern car it's whole life and is rust free. It doesn't look perfect and could use a paint job/bodywork (driver 1/4) if you want a show car. The rear seats, AC components, Radio and rear section of carpet have been removed but everything else is still intact. Please see the pictures and below for all the details and let me know if you have any questions. Car ran a 144.06 at Road Atlanta in Oct and a 123.5 at Roebling Road in Nov 2016 with more time left on the table.
Drivetrain
M52B28 installed in 2008 the following was done. Machining/pressure testing of the head to insure no cracking (Dover heads Greenville, SC) ?New valve seals, Complete top? end gasket kit (headgasket included)All new gaskets where parts for the swap were changed (i.e. the oil pan gasket and oil sump gasket for the e34 oil pan and sump). Complete cleaning of the block deck.
ZF M3 5 ?speed transmission?
M52 Clutch/flywheel
3.25 LSD
TRM OBD1 tune
21.5 Pink top injectors, flow tested and cleaned 1 year old
M50 manifold?
OBDI throttle body?with Bimmerworld Boot
OBDI wiring harness/ecu/sensors?
OBDII exhaust manifolds/custom piping.
AKG Race shifter.
AKG swap motor and trans mounts
Bimmerworld SS clutch line 1 year old
Race skid oil pan protector
Suspension/Brakes
Ground Control full coil over kit with camber plates and GC modified strut tubes reinforced and powder coated black 525f/850r 1 year old
O.E front wheel bearings 1 year old
Z3 1.9 steering rack with newer tie rods
AKG Sub frame and diff mounts 1 year old
Rear subframe with welded in I.E serrated rear camber/toe kit 1 year old
Bimmerworld FCAB's 1 year old
O.E control arms 1 year old
UUC spec e30 front and rear sway bar kit with reinforcements
Bimmerworld SS brakelines 1 year old
Rebuilt front calipers 1 year old
ABS delete with PFC 08 brake pads
Bimmerworld Brake cooling duct kit 1 year old
D-force wheels 15x7 with 205/50R15 Dunlop sat specs
Bimmerworld Race bullet head wheel studs 1 year old
Interior
Kirk 4 point roll bar
OMP passenger race seat
Bimerco halo driver with Planted side mounts seat 1 year old
Bimmerworld Race Seat mount
G-force Racing 6 point harnesses 1 year old
Sparco steering wheel with Momo hub
Misc stuff that has been replaced in the last year
Oil filter housing
Center support bearing
Guibo
Valve cover gasket, spark plugs and boots
Knock sensors
Radiator, expansion tank and hoses
Redline trans and diff fluid
Fuel tank and fuel pump
Battery
Pulley, belts and tensioner
Water pump
Oil changed with Motul 8100 5w40
List Date: 1/1/2017
For more info, click here to view the original listing: 1990 BMW 325I M52 Swap E30 HPDE car
--------------------------------------
This item is no longer available.
--------------------------------------
1990 BMW 325i Silver on black
Where do I start. . . this car has been so much fun and I have a lot of great memories in it. I'm looking to move on and buy a dedicated race car so this needs to find a new home. I have driven this car to Road Atlanta, Barber, AMP and Roebling Road without a single issue. I have replaced a lot of parts and put a ton of money into it over the past year. It's built right without any cut corners and I always use quality parts. It's been a southern car it's whole life and is rust free. It doesn't look perfect and could use a paint job/bodywork (driver 1/4) if you want a show car. The rear seats, AC components, Radio and rear section of carpet have been removed but everything else is still intact. Please see the pictures and below for all the details and let me know if you have any questions. Car ran a 144.06 at Road Atlanta in Oct and a 123.5 at Roebling Road in Nov 2016 with more time left on the table.
Drivetrain
M52B28 installed in 2008 the following was done. Machining/pressure testing of the head to insure no cracking (Dover heads Greenville, SC) ?New valve seals, Complete top? end gasket kit (headgasket included)All new gaskets where parts for the swap were changed (i.e. the oil pan gasket and oil sump gasket for the e34 oil pan and sump). Complete cleaning of the block deck.
ZF M3 5 ?speed transmission?
M52 Clutch/flywheel
3.25 LSD
TRM OBD1 tune
21.5 Pink top injectors, flow tested and cleaned 1 year old
M50 manifold?
OBDI throttle body?with Bimmerworld Boot
OBDI wiring harness/ecu/sensors?
OBDII exhaust manifolds/custom piping.
AKG Race shifter.
AKG swap motor and trans mounts
Bimmerworld SS clutch line 1 year old
Race skid oil pan protector
Suspension/Brakes
Ground Control full coil over kit with camber plates and GC modified strut tubes reinforced and powder coated black 525f/850r 1 year old
O.E front wheel bearings 1 year old
Z3 1.9 steering rack with newer tie rods
AKG Sub frame and diff mounts 1 year old
Rear subframe with welded in I.E serrated rear camber/toe kit 1 year old
Bimmerworld FCAB's 1 year old
O.E control arms 1 year old
UUC spec e30 front and rear sway bar kit with reinforcements
Bimmerworld SS brakelines 1 year old
Rebuilt front calipers 1 year old
ABS delete with PFC 08 brake pads
Bimmerworld Brake cooling duct kit 1 year old
D-force wheels 15x7 with 205/50R15 Dunlop sat specs
Bimmerworld Race bullet head wheel studs 1 year old
Interior
Kirk 4 point roll bar
OMP passenger race seat
Bimerco halo driver with Planted side mounts seat 1 year old
Bimmerworld Race Seat mount
G-force Racing 6 point harnesses 1 year old
Sparco steering wheel with Momo hub
Misc stuff that has been replaced in the last year
Oil filter housing
Center support bearing
Guibo
Valve cover gasket, spark plugs and boots
Knock sensors
Radiator, expansion tank and hoses
Redline trans and diff fluid
Fuel tank and fuel pump
Battery
Pulley, belts and tensioner
Water pump
Oil changed with Motul 8100 5w40
List Date: 1/1/2017
For more info, click here to view the original listing: 1990 BMW 325I M52 Swap E30 HPDE car
--------------------------------------
This item is no longer available.
--------------------------------------