Up for sale is a 1985 535i 5 speed car with a 3.25 limited slip. The car is Schwarz on black leather interior. It has had a lot of recent work done, but because of too many cars, this one needs to go.
I'd give the body and interior a solid 8 out of 10, and interior 9 out of 10. Only body damage is scratches on rear drivers quarter and trunk lid, no interior damage, seats are all clean and good stitching, door panels are all clean as well. Runs great, fun to drive, Bilstein Sports on H&R lowering springs and KMAC caster/camber plates all installed by a previous owner.
$4000
Work done recently:
- New heater blower fan
- Rebuilt 19lbs Bosch injectors
- Turner Motorsports/Conforti Chip
- New thermostat
- New center and outer tie rods
- New Steering idler arm and bushing
- New upper and lower control arms
- New alternator bushings
- New fuel pressure regulator
- Recent tires, battery, alignment, brake pads
- Long tube ceramic coated headers
- Catless midpipe
- BillyBoat cat-back exhaust
- Shifter linkage rebuilt, all new parts and short shifter installed
- Drivers door key cylinder replaced (matching key)
- AFM has been serviced as of last year
- Race Skids skid plate
Work outstanding:
- Needs contacts cleaned (tach and speedo are intermittent) common old bmw issue. New SI board was installed.
- Window regulators need rebuilding (rears aren't hooked up anymore and front drivers is slow)
- Rear taillight contacts need to be cleaned up
- AC doesn't work, never looked into it
I'd give the body and interior a solid 8 out of 10, and interior 9 out of 10. Only body damage is scratches on rear drivers quarter and trunk lid, no interior damage, seats are all clean and good stitching, door panels are all clean as well. Runs great, fun to drive, Bilstein Sports on H&R lowering springs and KMAC caster/camber plates all installed by a previous owner.
$4000
Work done recently:
- New heater blower fan
- Rebuilt 19lbs Bosch injectors
- Turner Motorsports/Conforti Chip
- New thermostat
- New center and outer tie rods
- New Steering idler arm and bushing
- New upper and lower control arms
- New alternator bushings
- New fuel pressure regulator
- Recent tires, battery, alignment, brake pads
- Long tube ceramic coated headers
- Catless midpipe
- BillyBoat cat-back exhaust
- Shifter linkage rebuilt, all new parts and short shifter installed
- Drivers door key cylinder replaced (matching key)
- AFM has been serviced as of last year
- Race Skids skid plate
Work outstanding:
- Needs contacts cleaned (tach and speedo are intermittent) common old bmw issue. New SI board was installed.
- Window regulators need rebuilding (rears aren't hooked up anymore and front drivers is slow)
- Rear taillight contacts need to be cleaned up
- AC doesn't work, never looked into it