So I have my new motor and trans assembled and back into the car (currently only set on the motor mounts) and I'm having one hell of a time trying to get the driveshaft and shift linkage all together.
Currently the shift linkage is only connected through the rear bushing (allowing it to slide back and forth) but im having a hard time lining the bitch clip area together, and more importantly getting the actual clip to rotate. once I get it through the appropriate holes. I'm not too worried about connecting the DSSR because it seems like I have much more access than the top half of the linkage.
Also the car is in neutral with the guibo already attached to the transmission, but getting the bolts from the driveshaft through them is proving to be another obstacle. I've already loosened the CSB and lowered the shaft but it does not provide much more clearance, and it's currently just short of being able to slide the bolts into place to mate everything together.
I would appreciate any tips or suggestions. You guys have been very helpful so far. Thanks in advance.
Currently the shift linkage is only connected through the rear bushing (allowing it to slide back and forth) but im having a hard time lining the bitch clip area together, and more importantly getting the actual clip to rotate. once I get it through the appropriate holes. I'm not too worried about connecting the DSSR because it seems like I have much more access than the top half of the linkage.
Also the car is in neutral with the guibo already attached to the transmission, but getting the bolts from the driveshaft through them is proving to be another obstacle. I've already loosened the CSB and lowered the shaft but it does not provide much more clearance, and it's currently just short of being able to slide the bolts into place to mate everything together.
I would appreciate any tips or suggestions. You guys have been very helpful so far. Thanks in advance.
Comment