Installed this cam in my 2.8L and degreed it only to find that my valves were making contact with the pistons. Even if I could get them to clear the pistons, I wouldn't have any room for adjusting the cam. My loss is your gain. This cam should work just fine in a 2.5 or maybe even in a 2.7i which hasn't had the head decked too much.
$350 + Shipping obo
I bought it "used" from another forum member who didn't know if it was ever actually installed. As you can see from the picture at the bottom, the lobes don't show any signs of wear.
Here is the plot (measured w/ valve lash set to zero):
And here is another showing my valve clearance, or lack thereof (measured w/ cam in same location as above and also w/ zero valve lash):
And, finally, here are some pictures of the cam:
$350 + Shipping obo
I bought it "used" from another forum member who didn't know if it was ever actually installed. As you can see from the picture at the bottom, the lobes don't show any signs of wear.
Here is the plot (measured w/ valve lash set to zero):
And here is another showing my valve clearance, or lack thereof (measured w/ cam in same location as above and also w/ zero valve lash):
And, finally, here are some pictures of the cam:
Comment