FS/FT M20 Engine Motor w/ 189k

[Thrizzle]

SOLD

I'm about to pull the m20 out of my 87 325is. Going to be replacing it with an s52.
I bought the car just a few months ago, but it came with some paperwork. So as of right now, the car has 189,106 original miles on it, the odometer does work. Some of the bigger maintenance noted:

174,932 mi:
-oil pan gasket
-new clutch, resurfaced flywheel
-rear crankshaft seal
-timing belt
-front crankshaft and cam seal
-water pump
-valve adjustment
-Also maybe worth noting the a/c compressor was replaced at 187k right before I bought it, with a remanufactured one, and recharged and all that good stuff

The engine pulls nice and strong, and is still in the car. I encourage anybody local that is interested, to come by and give it a test drive.
I'm not positive what will be included yet, as I'm unsure what parts I will be re-using for the swap. But it definitely will include:
-intake manifold
-exhaust manifold
-throttle body
-a/c compressor

I have paper work for all the mentioned stuff above, and more. Looking to get $600 obo, or am open to trades-looking for a suspension set up, or 24v swap parts.

Shoot me a PM if your interested

[HR2L]

I might be interested in this if your willing to work on the price a bit. Looking for a spare motor to possibly build. PM me where you located (Bay Area) and what exactly you are willing to include with the engine.

[Thrizzle]

PM'ed

[Thrizzle]

Bump, this engine's getting pulled soon, so come give it a test run!

[Thrizzle]

Bump, $500 OBO. Come give it a drive!

[Thrizzle]

Bump, engine is pulled, here is a new run down:

Just pulled an M20 out of my 87 325is. I bought the car just a few months ago, but it came with some paperwork. So as of right now, the engine has 189,106 original miles on it, the odometer does work. Some of the bigger maintenance noted:

At 174,932 mi:
-oil pan gasket
-rear crankshaft seal
-timing belt
-front crankshaft and cam seal
-water pump
-valve adjustment
-Also maybe worth noting the a/c compressor was replaced at 187k right before I bought it, with a remanufactured one.

Engine will come with:
-alternator
-power steering pump
-water pump
-airbox/maf
-a/c compressor
-intake/exhaust manifolds
-distributor/rotor/coil/spark plugs
-complete engine wiring harness with all sensors

Pretty much just pulled the engine and didn't touch it, so all the belts are even still on. I probably forgot some stuff, but if it bolts onto the engine, it's probably included. I have paper work to back up all the recent maintenance. Looking to get $500 obo.
If you're interested, shoot me a PM
-Andrew

[mr.vang]

pm'ed

[JGE30]

could i use this head on a 85 325e?

[Thrizzle]

Not sure if the head matches up with the e block, anyone know?