Just pulled cluster apart to replace what I assumed were dead batteries. Threw a multimeter on the batteries just for fun, and they are reading 2.85v or so if I place multimeter leads directly on the batteries. Place the leads on the solder tabs or whatever that then solder into the PCB, and I get 0V. I also get 0V on the solder nubs on the back side of the board - what gives??
-
-
Bueller? -
cracked solder joints maybeeeComment
-
put some new solder on there.
「'89 BMW 325is | '02 Mitsubishi Montero Limited | '2005 GMC Sierra 2500 Duramax | 2007 BMW M5 」
「my feedback thread」Comment
-
somewhere you have a a cold solder joint which let up.sigpicComment
Comment