If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Worked last night til late, got the exhaust tacked all the way back to the gas tank area. I may try to get it finish welded today, we'll see. I think this was more involved than fabbing the cage, Lol! A lot of fitting, trimming, tacking, re-fitting, re-trimming, re-tacking, ad-nauseum... The biggest issue was the fact that the two cylinder bank exhausts come down at different angles and end up at different points, length-wise. Trying to make them symmetrical, so they end up at the same point going into the cats, was a challenge. Plus, I was trying to keep the exhaust tucked up and even with or above the plane of the bottom of the front subframe, so it was tough... pics...
The plan is to place the mufflers sideways, since they have the inlet and outlet on the same sides, in the hollow area left by the gas tank. From the X-pipe, I'll use opposite 90 degree bends into each muffler and then out and to the rear...
Comment