Announcement

Collapse
No announcement yet.

Differntial problem concerning my new m50 swap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Differntial problem concerning my new m50 swap

    So I just got the car, and it formally had a 4 cylinder engine on it with a 4.1 open differntial. You know since I just got the car, I've been stepping on the gas and redlining but all of a sudden I hear gear whine in 1st gear and whine throughout the higher rpms. Also, I get a loud click everytime I step on the gas. Do I need to change it?
    Last edited by socalife; 09-18-2014, 10:24 AM. Reason: Spelling

    #2
    It's very likely.
    ADAMS Autosport

    Comment


      #3
      this can happen...



      or this....



      or both....

      2006 Subaru WRX
      1987 E30 Royalblau Metallic S52 OBDii
      1982 VW Westfalia 1.5d-gone

      Comment


        #4
        I would say she is smoked.

        Comment


          #5
          168mm Diffs dont like abuse or power..

          Check Us out on Facebook
          Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
          Full Product Line Tuning
          OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

          Comment


            #6
            What about the clunking noise from the back when I step on gas

            Comment


              #7
              That would be your small case diff crying for mercy.
              Build thread

              Bimmerlabs

              Comment


                #8
                Driveshaft bolts in the rear are tight? U joint have any slop?

                Comment


                  #9
                  Lol your car's bitchin for some LSD


                  RIP 02/25/15
                  http://www.r3vlimited.com/board/show...16#post4356816

                  Comment


                    #10
                    Those diffs won't take any abuse.


                    1991 325i
                    flickr
                    @sambhaskins

                    Comment


                      #11
                      Destroyed my small case diff with a 2l m20. Change le diff.
                      .................................................. ...................sigpic
                      .................................................. ............................. ......M50B25 3.1L stroker

                      Comment


                        #12
                        I'll disagree....... 168's are good with mild abuse up to 230-ish. If you're bustin it before then, then you've been neglecting the case and something other than simple "too much power" is/was the root of your trouble.
                        ADAMS Autosport

                        Comment


                          #13
                          Originally posted by socalife View Post
                          So I just got the car, and it formally had a 4 cylinder engine on it with a 4.1 open differntial. You know since I just got the car, I've been stepping on the gas and redlining but all of a sudden I hear gear whine in 1st gear and whine throughout the higher rpms. Also, I get a loud click everytime I step on the gas. Do I need to change it?
                          Have you checked your transmission / differential fluids?

                          Perhaps put a piece of cardboard under the car when u park and see if anything is leaking; If you are low on fluid for either it will be whiny
                          OBD1 M54/M52TU swap as a M50b25

                          Z4 non powered steering rack fits e30



                          Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

                          Comment

                          Working...
                          X