So, I did the fabled Z3 antenna swap for my non-functioning retractable antenna, and everything went relatively smoothly (other than it being 25 degrees outside while I was doing it).
Several other posters mentioned that the Z3 grommet fit rather perfectly on their vehicles, so I had one of those to go along with the installation, and I'm unimpressed with how it fits in the hole.
My question is, did I get a bad grommet, is this how people have theirs, or should I work on modifying the grommet itself to better fit the opening?
Any thoughts would be very appreciated. Excuse the dusty car, there's about a million leaves falling right now so I'm going to have to wait a week or two to clean her up.
Several other posters mentioned that the Z3 grommet fit rather perfectly on their vehicles, so I had one of those to go along with the installation, and I'm unimpressed with how it fits in the hole.
My question is, did I get a bad grommet, is this how people have theirs, or should I work on modifying the grommet itself to better fit the opening?
Any thoughts would be very appreciated. Excuse the dusty car, there's about a million leaves falling right now so I'm going to have to wait a week or two to clean her up.
Comment