Finally getting to the point of firing up my swap. Having a no crank issue...no clicks or anything
88 m3 using andrews adapter harness
zf320 with e36 m3 starter
All other electrical on the car works fine
12v at terminal 30 on the starter
With the terminal 50 disconnected I have 12v to ground with key in the ON position and START position
Terminal 50 connected shows 0v with key in the ON/START position
Jumped the solenoid and starter kicks over fine
What am missing?
Should the wire on terminal 50 have power in the on AND start position?
88 m3 using andrews adapter harness
zf320 with e36 m3 starter
All other electrical on the car works fine
12v at terminal 30 on the starter
With the terminal 50 disconnected I have 12v to ground with key in the ON position and START position
Terminal 50 connected shows 0v with key in the ON/START position
Jumped the solenoid and starter kicks over fine
What am missing?
Should the wire on terminal 50 have power in the on AND start position?
Comment