Guys,
Finishing a huge suspension overhaul, and ran into a surprise here.
What are your thoughts on the gap shown here between the rod and the rack. The rod wont thread past the shoulder just beyond the threaded portion.
so, the washer is not flush with the tie rod surface - see photo below.
Using lemforder rods with OE 325i rack. is this ok?
https://drive.google.com/open?id=0B-...ctTjJMX1l2TF9J
https://drive.google.com/open?id=0B-...hUSzc3VklreUFn
Finishing a huge suspension overhaul, and ran into a surprise here.
What are your thoughts on the gap shown here between the rod and the rack. The rod wont thread past the shoulder just beyond the threaded portion.
so, the washer is not flush with the tie rod surface - see photo below.
Using lemforder rods with OE 325i rack. is this ok?
https://drive.google.com/open?id=0B-...ctTjJMX1l2TF9J
https://drive.google.com/open?id=0B-...hUSzc3VklreUFn
Comment