Hey all,
When I completed my manual swap a few months ago, I used all new parts except for the transmission. On this 0articular G260, gears 1-5 work perfectly. However, about half the time I try to shift into reverse, it will pop out of gear when I apply any torque at all.
I've found it helps to put my car in reverse, shift out and shove it back in. Otherwise, it may pop out until it's happy.
What do you all think is happening? Am I missing the gate? Is the fork messed up? Did I install some bushings incorrectly? Any advice is welcome before I drop money on a new trans.
Thanks!
When I completed my manual swap a few months ago, I used all new parts except for the transmission. On this 0articular G260, gears 1-5 work perfectly. However, about half the time I try to shift into reverse, it will pop out of gear when I apply any torque at all.
I've found it helps to put my car in reverse, shift out and shove it back in. Otherwise, it may pop out until it's happy.
What do you all think is happening? Am I missing the gate? Is the fork messed up? Did I install some bushings incorrectly? Any advice is welcome before I drop money on a new trans.
Thanks!
Comment