Got an issue im trying to figure out if its a timing issue or its just the fact that my wasted spark isnt giving me enough spark here is what iv done
2.9 stroker metric mechanic baby six kit
-885 head
-272 cam
-2.7 bottom block
-holset hx35w
-2.5 i connecting rods ,
-block o ringed
-cx racing manifold
-bosch 55pin megasquirt v2/extra
-60lb injectors from kamotors
-diyautotune wasted spark coil pack
-MSD universal spark plugs
- fully regasketed
-spec stage 3 clutch
-ARP Studs
-Oem Headgasket
issue im having is it bucks but wont start yes iv looked around nothing with the same problem inter-cooler and piping was all connected this motor has not been turned on at all after the rebuild i just went straight to putting everything together and tried to crank it not i fixed my issue i had with the coils not firing idk if the spark is strong enough or not also don't know if i have the fuel lines connected right but my cylinders were soaked with fuel when the plugs got pulled out , but it bucks and almost fires up but than as it wants to fire the starter weakens and acts as if the battery has died but when its close to firing the intake backfires and basically tried ether which is bad but still back fired the ether
here a video battery's weak and something sounds like its robbing all the power big time even with another car boosting it car hasn't been started after rebuild which is what i should of done before
before i bent the rod just needed a mad valve adjustment
2.9 stroker metric mechanic baby six kit
-885 head
-272 cam
-2.7 bottom block
-holset hx35w
-2.5 i connecting rods ,
-block o ringed
-cx racing manifold
-bosch 55pin megasquirt v2/extra
-60lb injectors from kamotors
-diyautotune wasted spark coil pack
-MSD universal spark plugs
- fully regasketed
-spec stage 3 clutch
-ARP Studs
-Oem Headgasket
issue im having is it bucks but wont start yes iv looked around nothing with the same problem inter-cooler and piping was all connected this motor has not been turned on at all after the rebuild i just went straight to putting everything together and tried to crank it not i fixed my issue i had with the coils not firing idk if the spark is strong enough or not also don't know if i have the fuel lines connected right but my cylinders were soaked with fuel when the plugs got pulled out , but it bucks and almost fires up but than as it wants to fire the starter weakens and acts as if the battery has died but when its close to firing the intake backfires and basically tried ether which is bad but still back fired the ether
here a video battery's weak and something sounds like its robbing all the power big time even with another car boosting it car hasn't been started after rebuild which is what i should of done before
before i bent the rod just needed a mad valve adjustment
Comment