Announcement

Collapse
No announcement yet.

Virginia WTB thread

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Originally posted by phenryiv1 View Post
    Good deal. I know that my situation was a bit complex.

    no worries man.. I'm sure you'll be able to sell it whenever you do the swap on yours!
    '91 318i (Alpine) - daily
    '88 325ix (Zinno) - drive here and there!

    Comment


      Hit a deer.

      Looking for hood and drivers fender in AWII (Alpine 1 considered)for coupe/sedan and drivers side US elipsoid assembly (Hella) with minimal pitting.

      Hood and fender need to be RUST FREE and very little to NO dings/dents/filler.

      PM with pics and prices please.

      Located in Roanoke, Va.

      Comment


        still looking for a manual m30 trans as close to RVA as possible.
        sigpic
        1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
        1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
        1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]

        Comment


          I've got a g240 and clutch setup^ I'll sell it to you for cheap. Located in Chesapeake.
          = Heidi 1988 325 -> 335i. 7200rpm built M30

          Comment


            Looking for a complete M30/b34/35 close to Chesapeake VA. Looking to spend 450 or less.
            = Heidi 1988 325 -> 335i. 7200rpm built M30

            Comment


              Originally posted by totheredline View Post
              I've got a g240 and clutch setup^ I'll sell it to you for cheap. Located in Chesapeake.
              Although I appreciate it, I don't really trust a g240 behind an m30b35.
              sigpic
              1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
              1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
              1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]

              Comment


                Originally posted by McGyver View Post
                Although I appreciate it, I don't really trust a g240 behind an m30b35.
                I don't blame you. I didn't trust it either, so I went with a getrag 265/6
                = Heidi 1988 325 -> 335i. 7200rpm built M30

                Comment


                  WTB plastic bumpers for diving board swap. does not have to be in perfect condition.

                  m50 with less than 200k miles

                  4x100 wheels 15-16"

                  driver side sport seat

                  crack free dash

                  h&r or eibach springs (1984 325e)

                  please PM me

                  Comment


                    Looking for an ETA driveshaft. Less than $100
                    = Heidi 1988 325 -> 335i. 7200rpm built M30

                    Comment


                      **Tan vinyl sedan rear seat bottom

                      **Tan rear carpet section just under the rear seat bottom also for a sedan.

                      I'm in Chesapeake, VA but could pick this stuff up in Richmond or anywhere in between. Thanks!

                      Comment


                        Selling my complete built m30 setup. PM for info.

                        Sent from my XT1585 using Tapatalk
                        = Heidi 1988 325 -> 335i. 7200rpm built M30

                        Comment


                          Also looking for front seat mounting rails that are in good shape. Some rust is ok, but not rusted to hell. Looking for all 4 rails. Don't need any of the hardware. Located in Chesapeake 23320

                          Comment


                            I have front seat rails, all 4 I think, I'll check. Also have a rear seat from a coupe - different than sedan? Can deliver to Richmond.

                            Comment


                              Looking for a front nose clip for a 2002. No (major) rust or Bondo please... I know it's a tall order and not for an e30.

                              Comment


                                I have one, it's fairly clean, and is in Beltsville, MD. Feel free to PM for details, but I don't think I can get pictures as it's in storage above my brothers garage. Need any more 02 parts?

                                Comment

                                Working...
                                X