325e turbo / fun project

[codrum]

Looks/sounds great and I'm loving the zip-tied wideband gauge to the steering column :)

I also highly recommend overlaying your spark advance in your top log window. Then press the up-arrow on your keyboard in MLV for the highest resolution in your pulls. You can really see where to smooth out the timing table to get consistently smooth boost. Looks like you've got some break-up when getting on it in third.

I spent the weekend on mine and it made a huge difference. Great build, can't wait to see it swapped over.

[Cyrix2k]

Thanks for the suggestions. I ended the video early because I had the AE disabled and there was a lean break up. Prior to that I had the AE 50/50 between MAP & TPS based and I think it was acting as a crutch for additional fueling (the MAP part specifically). I can't wait to get it all swapped over either :) It's fun having a complete ratted out car, but I'm ready to have a nice interior again.

[Cyrix2k]

quick bump - been tuning. Also shot this exhaust video

http://youtu.be/84HiA6qFJJs

[Dreißiger]

1987 325e Turbo

Quick question, I am installing a turbo in my 1987 325e just got the wideband set up and have the ms2 pnp wired up. I installed the 60-2 trigger wheel with the sensor but I have no clue where the wires for the trigger wheel sensor link up to. Was wondering if you could help me out?
This should be the last step to getting the megasquirt running hopefully.
Thank you.

[squidmaster]

The signal wire runs through a resistor (10-20k, or use a pot) to the VR+