My driveshaft at first wasnt fitting at all, it was about 1-1.5 inches too long. I am not 100% sure on how to adjust it, it looks like there is a collar you can screw backwards near the splines by the CSB. I managed just to push it back together a bit, but I still need about another 1/4 inch.
Do I just unscre this collar? I wanted to know if it was reverse threaded too. I need to have it so I am unable to see any of the splines I think.... I hope it pushs back that far.
Thanks
Do I just unscre this collar? I wanted to know if it was reverse threaded too. I need to have it so I am unable to see any of the splines I think.... I hope it pushs back that far.
Thanks
Comment