so the ones i didn't assign a function to, i don't need them for the c101?
Announcement
Collapse
No announcement yet.
S52 Build aka Fresh
Collapse
X
-
not necessarily.
Check Us out on Facebook
Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
Full Product Line Tuning
OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread
Comment
-
need help figuring this out...
1 blank
2 blank
3 blank
4 black/blue 0.5 AC Compressor relay
5 black/gray 0.5 A/C Compressor Input
6 violet/gray 0.5 Climate control regulator module
7 green 0.5 DME power from ignition switch
8 gray 0.5 Check engine light
9 blank
10 blue/yellow 0.75 Back up lights
11 brown/yellow 0.5 Coolant temp gauge
12 brown/violet 0.5 Coolant temp sender
13 green/violet 0.75 Fuel pump relay
14 black/white 0.5 speed from instrument cluster
15 black/green 0.5 Starter motor
16 white/yellow 0.5 ?
17 white/violet 0.5 Diagnostics DME connector
18 black/yellow 1 Starter
19 white/green 0.5 Diagnostics connector
20 black 0.5 Engine speed
21 green 1 Ignition switch
22 green/white 0.75 o2 sensor heater switch
23 brown/green 0.5 Oil pressure switch
24 white/black 0.5 Fuel consumption
25 blue/yellow 0.5 Alternator
Comment
-
Originally posted by /\/\ III View Postneed help figuring this out...
1 blank
2 blank
3 blank
4 black/blue 0.5 AC Compressor relay
5 black/gray 0.5 A/C Compressor Input
6 violet/gray 0.5 Climate control regulator module
7 green 0.5 DME power from ignition switch
8 gray 0.5 Check engine light
9 blank
10 blue/yellow 0.75 Back up lights
11 brown/yellow 0.5 Coolant temp gauge
12 brown/violet 0.5 Coolant temp sender
13 green/violet 0.75 Fuel pump relay
14 black/white 0.5 speed from instrument cluster
15 black/green 0.5 Starter motor
16 white/yellow 0.5 ?
17 white/violet 0.5 Diagnostics DME connector
18 black/yellow 1 Starter
19 white/green 0.5 Diagnostics connector
20 black 0.5 Engine speed
21 green 1 Ignition switch
22 green/white 0.75 o2 sensor heater switch
23 brown/green 0.5 Oil pressure switch
24 white/black 0.5 Fuel consumption
25 blue/yellow 0.5 Alternator1989 E30 Zinnoberrot Vert 325i OBD1 S52 turbo;IP
Comment
-
I'm putting my engine back together and got a few bolts I need your help on. I don't have my M50 manifold on yet, so I am sure some of these bolts go there.
Bolt C1-4: pulleys?
Bolt D: use with harmonic dampner if not with ac
Bolt J: power steering
Bolt K: clutch assembly
Bolt N1: extra header bolts? Headers already on block
Bolt N2: are smaller than N1, same color as N1
Last edited by /\/\ III; 11-26-2014, 11:18 AM.
Comment
-
Here's how she looks now...a little dirty
Parts list
+Extended gasket for OBD2 throttle body to M50 intake manifold
+Tube for ICV and CCV to M50 manifold
+Water pump
+E34 oil pan
+E34 throttle cable
+e21 brake booster or Porsche 944 booster or E32 master, 2002tii remote reservoir
+radiator: undecided (M42 rad(new) with a 16" spal pusher) or mishimoto 16in puller
+Shift Lever and Linkage Z3
+Steering System (steering guibo removal)
Possible lists:
http://www.r3vlimited.com/board/showthread.php?t=340797
Spark Plugs
A/C Belt
Main belt
Thermostat
Thermostat Housing
Coolant temp sensors
Water Pump
Upper Coolant Hose
Lower Coolant Hose
Oil filter
Guibo
Valve cover gasket set
Motor Mounts
Intake Boot
E34 Oil Pump Gasket
E34 Oil Pan Gasket
E34 Oilpan, pick up, pump, dipstick
Shifter rod joint
Delrin Shift Carrier Bushing
E34 throttle cable
Spider Hose
Idler Pulley
Clutch & Flywheel
rear main seal
Pilot Bearing
Vacuum Line ICV Connector
Vacuum line to ICV
Intake Manifold vacuum
Intake Manifold vacuum thinner line
O2 Sensor
This roughly comes out to $1400 based on a previous build.
If you're getting a ZF Gearbox:
5th gear lean fix for ZF gearbox
5th gear spring
Shifter Detent Pin (5th Gear)
The list in that link is far more comprehensive though.Last edited by /\/\ III; 12-17-2014, 05:15 AM.
Comment
Comment