No Low Beams - Switch and Relay Already Replaced

[Lof8]

Just like the title says. I have no low beam lights. I swapped around some relays and that didn't help, so I swapped in a new switch on the column. Still no low beams :( High beams have been fine the whole time.

Thanks for any advice.

[Dakotademon7]

Did you check fuses ?

[Lof8]

Did you check fuses ?

Lol, no I haven't. I will do that next. Thanks

[Lof8]

The fuses are good too.

For a while, my low beams were finicky, and I could jiggle the stalk on the column to get them to work. That is what led me to believe the switch on the column was bad. The newly installed switch made no difference. Does this switch go bad commonly? Possibly the junkyard switch I swapped in is bad too?

Are there other components to this system I'm overlooking?

[Lof8]

bump

[M-technik-3]

Hate to ask, but sealed beam vs hX bulbs? Have you checks the simple are the filaments good?

[trippmann]

check the collection of grounds on the steering column and in the engine bay right next to the air box. remove the bolt, sand down all of the "O"'s on the end of the wires, sand down the mounting point where they connect to.

my headlights were flickering after a HID/smiley upgrade. after cleaning the grounds my problem went away.