So when I first got my car the trans was bad and needed swapped out. I swapped it with another getrag at the time, but noticed I had two different sized Throw out bearings. One for shallow trans and one for a deep trans, but cant remember what is installed.
Currently in the middle of a swap and used the throw out bearing from the old m20 getrag, dual mass that I know of. Now that the ZF is in and the clutch is bled I noticed I have a very low clutch engagement even after messing with the eccentric bolt. Could this be caused by the throw out bearing or is it something else? The only thing in the clutch system that changed clutch wise is the slave cylinder and trans.
Currently in the middle of a swap and used the throw out bearing from the old m20 getrag, dual mass that I know of. Now that the ZF is in and the clutch is bled I noticed I have a very low clutch engagement even after messing with the eccentric bolt. Could this be caused by the throw out bearing or is it something else? The only thing in the clutch system that changed clutch wise is the slave cylinder and trans.
Comment