M3 Sport Evolution. Passion and restoration.

[MukeM3]

Can you tell part number of lights holes seals? if its goes separately from front grills.

You can't buy them separately. These seals comes with Sport Evo grills, but they are NLA. Here: #2 and #3: http://bmwfans.info/parts-catalog/E3...trim/grille_2/

Something made. New inner and outer lists:

[IMG][/IMG]

[IMG][/IMG]

[CurrusDei]

Are the evo 3 grilles still available? If so, mind to share the part no?


Sent from my iPhone using Tapatalk

[Lietuvis]

Are the evo 3 grilles still available? If so, mind to share the part no?


Sent from my iPhone using Tapatalk

Evo 3 central grills still available part no: 51132233001

[pandaboo911]

I was reading this thread around 1am when r3vlimited servers went down. I cried.

[MukeM3]

New rear emblem installed in place. With original instructions were easy.


[IMG][/IMG]

[IMG][/IMG]


At first I marked the right place with tape.

[IMG][/IMG]

Ready.

[IMG][/IMG]

Also new engine compartment seal and Evo's fenders / bonnet gaskets and fuse box cover.

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

All in Place.

[IMG][/IMG]

Couple of stickers.

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

[CurrusDei]

M3 Sport Evolution. Passion and restoration.

Quick question for you. How did you get the sound insulation to lay so flat? mine is pulling forward (away from the fire wall) along the top and doesnt sit as flat as yours does overall, did you need to heat it or apply an adhesive?



Here's mine...

[reelizmpro]

wow, good job. Super clean.

[MukeM3]

Quick question for you. How did you get the sound insulation to lay so flat? mine is pulling forward (away from the fire wall) along the top and doesnt sit as flat as yours does overall, did you need to heat it or apply an adhesive?

I used (as factory) contact glue. This one works fine: http://www.pattex.co.za/en/products/contact.html
In addition, I have the blower housing cover plate in place and this will keep also sound insulation in place.

[CurrusDei]

Interesting. Did you glue just the loose top parts or the entire thing?


Sent from my iPhone using Tapatalk

[pipeuy]

Brilliant just brilliant.

[MukeM3]

Interesting. Did you glue just the loose top parts or the entire thing?

Only upper edge of insulation. About one inch width.

[MukeM3]

Last parts begins to find their place.

[IMG][/IMG]

[IMG][/IMG]

Finally, a new steering wheel and gear knob.


[IMG][/IMG]

Slightly like "empty feeling" now. After this I sat on a chair in the garage probably two hours and watched a car. Almost exactly 7 years went to work. Then the question, what to do after this.

I put those kinds of tuning wheels on the car, as in the original Evo-wheels had not yet applied new tires.

[IMG][/IMG]

[Powling]

Wow...after all that its just done?! Amazing attention to detail.

[CurrusDei]

Bravo sir. I'm already thinking about what to do after "done". It's a tough one. I'm thinking 911. Your car is gorgeous. Hopefully I'll be done in 14 months


Sent from my iPhone using Tapatalk

[ThatOneEuroE30]

Wow. Just wow. Car is amazing man. I wondered the same thing so I got more projects haha