German Engineering Coilovers

[kamotors]

awesome

[4ce30]

DAMN! I just bought a set of 5in rear springs a few days ago.. wish i would have held off and bought a set from you!!!

[Paradox]

Just sent the money - 5" springs for the front please!

[einstein57]

Went to the anodizer and they changed their lot configuration on me. The want to charge me for 3 lots instead of one big one. Found a different company that was recommended to me by my wheel stripper and they will only charge by the part since i have several hundred. Only thing is they don't do bright dipping so they will not be shiny. They will look like the center adjuster.

[VitalkaE30]

pm'd

[ian e30 318is]

pm'd you a few questions

[325_e30]

pmed

[Paradox]

Just wondering if you have a better idea yet when these are being shipped out.

[pandaboo911]

I'm also interested in just the rear setup. Adjusters/perch/spring.

LMK if it is possible, if you get more rear adjusters

Don't feel like paying 400$ for vorshlag's rear setup

[Leon T. Trout]

Do the front adjusters just sit on the top of the gland nut?

My plan:
GE Coilovers with 6" springs
2" removed from strut tubes
IX KYB Gas-A-Just Front inserts KG4539 w/ 1" spacer
Camaro Gas-A-Just Rear KG5562

Sound good? I think it will be a great setup for less than $500.

[einstein57]

Just wondering if you have a better idea yet when these are being shipped out.

By the end of next week.

I'm also interested in just the rear setup. Adjusters/perch/spring.

LMK if it is possible, if you get more rear adjusters

Don't feel like paying 400$ for vorshlag's rear setup

Rear adjusters are on limited supply. However i might have an alternative solution. I can shorten some front sleeves on my lathe and make an ABS centering insert for them.

Do the front adjusters just sit on the top of the gland nut?

My plan:
GE Coilovers with 6" springs
2" removed from strut tubes
IX KYB Gas-A-Just Front inserts KG4539 w/ 1" spacer
Camaro Gas-A-Just Rear KG5562

Sound good? I think it will be a great setup for less than $500.

No. They are below the gland nut. KYB ix inserts will probably within a year. Go with the MR2 inserts and replace your bearings for the strut mounts.

[Leon T. Trout]

No. They are below the gland nut. KYB ix inserts will probably within a year. Go with the MR2 inserts and replace your bearings for the strut mounts.

So will I have to weld a flange on the tube? Just want to be prepared. I only went with the ix inserts because I couldn't find a part # for mr2 gas-a-justs. I'll keep looking.

Edit: kyb doesn't make gas-a-justs for the mr2. Any other options for shorter cheaper struts? Agxs aren't in the budget

Sent from my SGH-T989 using Tapatalk 2

[einstein57]

If your going to section the strut tubes then you should weld on a new one. Start fresh for clean results. Although if you wanted to be lazy you could theoretically section it below the factory perch keeping it still in use but its kinda silly unless your in a major rush and don't have time to grind down the old ones.

Kyb does make regular inserts for the mr2/celica

[EVillalonRN]

Is this part of a group buy?

[einstein57]

Yes. Price will go up once i start shipping.