I've got a Magnaflow 14816 I want to get put on my 325is. It has got a single 2.25" inlet and going to require some fabrication of a y-pipe.
I think a competent exhaust shop should be able to do that part but I was also wanting to get rid of the cat and just run piping from the down pipes back to the muffler and getting a shop to do that is a different story. Any shop recommendations or suggestions in the Dallas area (I'm in Mckinney)?? I'm usually a diyer but sadly can't fabricate/weld.
I think a competent exhaust shop should be able to do that part but I was also wanting to get rid of the cat and just run piping from the down pipes back to the muffler and getting a shop to do that is a different story. Any shop recommendations or suggestions in the Dallas area (I'm in Mckinney)?? I'm usually a diyer but sadly can't fabricate/weld.
Comment