Announcement

Collapse
No announcement yet.

Brake Light in Cluster won't go out

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Brake Light in Cluster won't go out

    On start up when pressing the brake, the brake light in the cluster does not go out as it should. I just swapped for a new dash, new bulbs, etc.

    Also, side indicator lights remain on even when car if off and light switch is not on...
    '89 325ix
    '88 M6 Royal Blue
    '13 128i "M-Sport"
    '04 ZHP Mystic Blue-SOLD
    '02 E46 330xi-SOLD
    '89 325i Laachssilber metallic-SOLD
    '89 325i Bronzit-SOLD

    #2
    Which light? The one for the pad sensor or the other brake light? The other is for fluid I think... check the connector. If it's the pad sensor, you could have some bad wiring as well. When I last did my brake job, I just didn't bother using the pad sensors... my wiring was messed. I just pulled the bulb from the cluster.
    Estoguy
    1986 BMW 325, Alpenweiss ~ "Elsa"

    Need a photographer, come visit my site: http://estoguy.wix.com/unique-perspectives

    Comment


      #3
      If you mean brake lining light, those are super common to fail. A main board refurbish will fix it.
      Owner - Bavarian Restoration
      BMW and European Electronics Repair and Restoration
      www.BavRest.com
      My Feedback Thread
      Our Facebook!
      Follow our Instagram!

      Comment


        #4
        brake lining light

        make sure the brakes are good, also make sure the wires did not just wear through like mine did. some electrical tape fixed my light problem

        Comment

        Working...
        X