Hi all,
I have read the ms startup guide and gotten all the way to the end aaaaannnd no start :(
I have MS3x V3.57
A few steps that I noticed along the way were
- My tps is not synced, and wont read tps signal even when i use the sync feature. I dont think this is important to start up, or tuning in general since i am going speed density.
- My coolant temp sensor is not calibrated correctly, reading 180*F when the engine is cold. I know the sensor is good.
-My fuel pump will not prime. I am unsure why, and almost positive that this is the issue. I can confirm that purple wire 37 labeled "fuel pump" is connected to my fuel pump relay.
I am unsure of where to check next. Any help is appreciated.
I have read the ms startup guide and gotten all the way to the end aaaaannnd no start :(
I have MS3x V3.57
A few steps that I noticed along the way were
- My tps is not synced, and wont read tps signal even when i use the sync feature. I dont think this is important to start up, or tuning in general since i am going speed density.
- My coolant temp sensor is not calibrated correctly, reading 180*F when the engine is cold. I know the sensor is good.
-My fuel pump will not prime. I am unsure why, and almost positive that this is the issue. I can confirm that purple wire 37 labeled "fuel pump" is connected to my fuel pump relay.
I am unsure of where to check next. Any help is appreciated.