I wondering how to add a CPS to my build. I have wasted spark setup and a Distributor block off plate with CPS from MRT, which is sold through BimmerHeads.com Do I remove the crank position sensor and wire in the new CPS or do I run them in tandem? If so, where on the board should i wire in the signal from the new CPS?
Announcement
Collapse
No announcement yet.
How to add Cam Position Sensor to WHODWHO MS2PNP with wasted spark
Collapse
X
-
How to add Cam Position Sensor to WHODWHO MS2PNP with wasted spark
Last edited by dirtyEthirtyIX; 08-09-2017, 08:30 PM.Tags: None
-
you can get dizzy blockoff plates that will accept a cam sensor (or modify yours) and add a single tooth on the rotor adapter. you use both the original Crank sensor and a cam sensor89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...
new build thread http://www.r3vlimited.com/board/showthread.php?t=317505
-
The whodwho plug and play is based off microsquirt... check this link
https://www.diyautotune.com/support/...n-control/#cam It seems to explain how to wire it in although I'll admit I'm not too familiar with microsquirt. I'd try to get in touch with whodwho and ask him directly before making any changes.
Comment
Comment