As some of you may know that im working on a 86 325e project (check out my build thread here: http://www.r3vlimited.com/board/showthread.php?t=401919) and i just did a late model plastic bumper conversion on the rear. But the early e30s have the short valances that dont look very clean as do the late model e30s. Is there any good options of rear aprons that will suit the early e30s with plastic rear bumper?
Announcement
Collapse
No announcement yet.
Early E30 rear valance options??
Collapse
X
-
Originally posted by joecrotch View PostI would love to find this out too. My current build is an 87. Just finishing up drivetrain so starting to plan the body out. How was the bumper swap?
Sent from my Pixel XL using Tapatalk
I was doing more searching on it and i think imma go with the DTM lower rear apron. Ive seen Sebo's early e30 build thread and it looks awesome
Comment
-
Originally posted by danielpak_ek9 View PostHavent started on the front but the front is fairly simple its just a bolt on swap. And you have to cut off the tow hooks in the front. The rear was a bit more complicated but i got it mounted and it looks pretty good id say but without a rear valance its unfinished right now..
I was doing more searching on it and i think imma go with the DTM lower rear apron. Ive seen Sebo's early e30 build thread and it looks awesome
Sent from my Pixel XL using Tapatalksigpic
Comment
-
Just my two cents but I found it cheaper to get that dtmfiberwerks rear valance here - http://www.modbargains.com/dtm-fiber...mper-apron.htm
Can't wait to get my car priorities straight then finally pick it up along with some is skirts!FS: Plug n Play Second Trunk Light !
My Parts for Sale Thread~
x 1984 325e 2.7i ~ CastroMotorsport Built x Daily Driven
Comment
Comment