So I got an Mtech 2 370mm. wheel recently and went to install it today but ran into some issues. Put the wheel in and it was getting stuck on the slip ring pin so grabbed some pliers and pulled it out.
I then installed original Spacer plus two more. Then put on the wheel and then another spacer just to get the wheel nut to tighten down enough to drive it and there is still a little play in the wheel. Now there is a huge gap between the back of the wheel and the steering column interface. I have a 91 325i and did airbag delete already. Am I doing this wrong or missing something? I just want the wheel to fit flush and tight properly.
The way it looks I guess I will have to fit a very thick spacer in front of the steering wheel.
I then installed original Spacer plus two more. Then put on the wheel and then another spacer just to get the wheel nut to tighten down enough to drive it and there is still a little play in the wheel. Now there is a huge gap between the back of the wheel and the steering column interface. I have a 91 325i and did airbag delete already. Am I doing this wrong or missing something? I just want the wheel to fit flush and tight properly.
The way it looks I guess I will have to fit a very thick spacer in front of the steering wheel.
Comment