Hi, finished up my 2.7 a few weeks back. I've only started the car a few times.
Has cam, 19lb injectors, and sssquid chip.
First start up it ran pretty well, broke in the cam at 2000 rpm so for around 20 minutes
All good.
The next couple times I've started it hasn't run aswell. And the last time was the worst.
I could smell gas, looked at the plugs a little wet and black and fouled.
Obviously why it was probably running well the first time, plugs were new and clean.
Could the chip not have adapted the settings yet? Normally when you install a chip you have to drive a little for it to learn right?
I don't see any vacuum leaks, but I'm going to give it a closer look?
Or atleast take the oil fill cap off when it's running to see if there's a change.
Other thoughts?
Has cam, 19lb injectors, and sssquid chip.
First start up it ran pretty well, broke in the cam at 2000 rpm so for around 20 minutes
All good.
The next couple times I've started it hasn't run aswell. And the last time was the worst.
I could smell gas, looked at the plugs a little wet and black and fouled.
Obviously why it was probably running well the first time, plugs were new and clean.
Could the chip not have adapted the settings yet? Normally when you install a chip you have to drive a little for it to learn right?
I don't see any vacuum leaks, but I'm going to give it a closer look?
Or atleast take the oil fill cap off when it's running to see if there's a change.
Other thoughts?
Comment