Rocker Panel Cavity Wax

[86bmw325e]

Hey all,

I'm having the passenger side rocker panel repaired and repainted and was planning on filling both rockers with fluid film (lanolin)( I have the 360 extension wand). The problem being, I can't find a way into the rocker. There doesn't appear to be any holes or access. At first I though the lift points would give me access but that does not appear to be the case. How does everyone else reach their inner rockers for rust proofing? If I have to drill holes, where would be an ideal location?




Sent from my iPhone using Tapatalk

[86bmw325e]

Bump


Sent from my iPhone using Tapatalk

[Northern]

My car already has holes, which of course started to rust...

If it were a coupe, I'd say just pull the rear "door" cards and snake it up from there... but a sedan, maybe pull off the door sill trim (carefully - sliding it forward and back will get it off a few of the clips, but the clips like to break) then pull the carpet back to expose these holes:



Not sure if they exist in the rear too?

[86bmw325e]

I'll have to take a look. Looks like a real viable option though! Thanks Northern!


Sent from my iPhone using Tapatalk

[86bmw325e]

Pulled back the carpet and found sufficient access to the inner rocker through these holes. Thanks for the help!


Sent from my iPhone using Tapatalk

[straight6pwr]

[86bmw325e]

Rocker Panel Cavity Wax

Lol



Sent from my iPhone using Tapatalk

[NC325iC]

where is this going?

[86bmw325e]

Going to coat the underside of the vehicle and fill the inside of the rocker panels with it


Sent from my iPhone using Tapatalk