I'm swapping an M30B35 into my 84 E30. I picked up a Getrag 260/6 transmission to go with the M30.
I was just trying to mate the two up but I couldn't quite seem to get the tranny flush with the engine. Despite my efforts there remained about a 1/2" gap.
I'm wondering if the input shaft on the transmission is somehow hanging out too far on the transmission. I've never seen a Getrag 260/6 outside of a car but from pictures I've seen online, my input shaft seems to protruding a bit further than those. See the pictures below.
[IMG][/IMG]
I was just trying to mate the two up but I couldn't quite seem to get the tranny flush with the engine. Despite my efforts there remained about a 1/2" gap.
I'm wondering if the input shaft on the transmission is somehow hanging out too far on the transmission. I've never seen a Getrag 260/6 outside of a car but from pictures I've seen online, my input shaft seems to protruding a bit further than those. See the pictures below.
[IMG][/IMG]
Comment