I have my car for part out in another thread, i have my eye on another car so may have this stuff for sale. If there is interest I WILL sell it.
I have pics of the motor but will get more pics tommorow if there is interest.
E30 M3 5-Lug setup - front Struts shortened for Ground controls, great condition no rust, repainted Includes Butterfly's (knuckles). Rear trailing arms with hubs. Front and rear cross-drilled brake rotors. Front M3 calipers, just needs Control arms and rear calipers Gonna want $1600
Borbet type A's staggered 9x16 and 7.5x16 Flat center caps with no writing on them, needs bolts to hold them onto the wheel (I was gonna get some from Home depot) not perfect These will need refinishing, I took them to a wheel shop to get them done but called this morning and they said they hadn't got to them yet so if you want them as-is I can do it. They will need repainting and the lips polishing this can be done DIY, there is some scratches and curbing but not bad. There is a small bend in one of the rears. i bought them off a forum member here and just want out of them what i put in $650 + shipping
M50 Motor pulled by me from a '93 E34 525i 19x,xxx miles ran really well so I bought the car to pull the engine from. There is some oil leaks but nothing too serious, started right up and ran well , didnt missfire or stutter ran well. Great for a E30 swap as it has the right oil pan etc etc includes the Correct E34 wiring harness. Attached is a 5 speed trans but the mount tabs are broken off, clutch was replaced recently by PO. I have a AKG style wiring adapter to PnP for this harness into E30 included. $750
German Check control Panel $45 shipped
I have pics of the motor but will get more pics tommorow if there is interest.
E30 M3 5-Lug setup - front Struts shortened for Ground controls, great condition no rust, repainted Includes Butterfly's (knuckles). Rear trailing arms with hubs. Front and rear cross-drilled brake rotors. Front M3 calipers, just needs Control arms and rear calipers Gonna want $1600
Borbet type A's staggered 9x16 and 7.5x16 Flat center caps with no writing on them, needs bolts to hold them onto the wheel (I was gonna get some from Home depot) not perfect These will need refinishing, I took them to a wheel shop to get them done but called this morning and they said they hadn't got to them yet so if you want them as-is I can do it. They will need repainting and the lips polishing this can be done DIY, there is some scratches and curbing but not bad. There is a small bend in one of the rears. i bought them off a forum member here and just want out of them what i put in $650 + shipping
M50 Motor pulled by me from a '93 E34 525i 19x,xxx miles ran really well so I bought the car to pull the engine from. There is some oil leaks but nothing too serious, started right up and ran well , didnt missfire or stutter ran well. Great for a E30 swap as it has the right oil pan etc etc includes the Correct E34 wiring harness. Attached is a 5 speed trans but the mount tabs are broken off, clutch was replaced recently by PO. I have a AKG style wiring adapter to PnP for this harness into E30 included. $750
German Check control Panel $45 shipped
Comment