wow that is a very nice cup holder, and great design.
Announcement
Collapse
No announcement yet.
Custom Cup Holders for BMW e30, e32, e34 and e38
Collapse
X
-
Originally posted by Philipangoo View Postwow that is a very nice cup holder, and great design.2013 C250
2012 ALPINA B7
2006 X5 e53
2001 740i e38
1998 e320 s210
2016 Kawi Vaquero
Comment
-
Subscribed.
SC*AR (Schwarz Army)
No longer stock ride height, rolling as low as a daily driver in New England should without worrying about breaking an oil pan. :up:
Comment
-
Originally posted by Asbradley21 View PostYou really should make one for the rear console slot next to the ebrake, I would be all over that. I use the front one too much to fill it up with that...
Actually I did make one of those for an e30 I owned back in 04. There actually was a hole in there from the previous owner which I wanted to cover up. Location is actually ideal it's in perfect reach of the driver and passenger seat.
I could possibly look into making these as well but they would require at least 2 screws on the e-brake side to hold it. You can see the screws in the picture. This one straddles the center console and I would also sew a wrap for it.
I would also see about making one that would go over top of the rear console pocket but it would also need to be screwed down which would leave holes if it was ever removed.2013 C250
2012 ALPINA B7
2006 X5 e53
2001 740i e38
1998 e320 s210
2016 Kawi Vaquero
Comment
-
Originally posted by SFGadgetGuy View PostActually I did make one of those for an e30 I owned back in 04. There actually was a hole in there from the previous owner which I wanted to cover up. Location is actually ideal it's in perfect reach of the driver and passenger seat.
I could possibly look into making these as well but they would require at least 2 screws on the e-brake side to hold it. You can see the screws in the picture. This one straddles the center console and I would also sew a wrap for it.
I would also see about making one that would go over top of the rear console pocket but it would also need to be screwed down which would leave holes if it was ever removed.
S54B32 swap in progress. Status: Getting There
Comment
-
Originally posted by elguapo84 View Postwant to see pics w/ the socket.
The quarter in the picture is where the socket would go. It's just a plain 12v socket with a small chrome ring on top. There is no cap but possible the original lighter may fit. I have to wait to receive them before I would know more on it. I tried to source one's with a cap but the only one's I found were for marine use and the cost was to high.2013 C250
2012 ALPINA B7
2006 X5 e53
2001 740i e38
1998 e320 s210
2016 Kawi Vaquero
Comment
Comment