New parts car / engine / tranny / interior / exterior / glass : Video : Pictures

[ethirtydavid]

All PM's replied

parts list updated

[ethirtydavid]

all PMs replied, you guys are making this easy

[aljofrank]

pm sent about ellipsoids

[mbulsa]

hows the leather on the mtech steering wheels? any pictures?

[ethirtydavid]

Leather on both are good. There are some worn areas but nothing beyond normal wear, no cuts rips or tears and stitching in tact. One sold just a few minutes ago, second one still for sale 70 bucks.

PMs replied, prices updated

[mbulsa]

you know what, I think i'll have to take it. what's your paypal?

[ethirtydavid]

PMed
>>

[Zasz]

What's the deal with the subframe and control arms?

[NC325iC]

think you could do me a favor??

walk out into the garage with a ruler or tape measure or something and take 3 measurements for me inside the bellhousing with regard to the tube that protects the input shaft.

1) the overall length of the tube from where in meets with the Trans casing to where the shaft comes out of it.
2) from the surface where the pivot arm clips on (where the clip comes thru the holes on that flat surface or where the slave cylinder comes through the bellhousing) to where the shaft comes out of the tube (end of the tube).
3) from the mounting surface on the bellhousing to where the shaft comes out of the tube.

[ethirtydavid]

What's the deal with the subframe and control arms?

front control arms are free if you come grab them - front subframe had a slight bend.

[ethirtydavid]

think you could do me a favor??

walk out into the garage with a ruler or tape measure or something and take 3 measurements for me inside the bellhousing with regard to the tube that protects the input shaft.

1) the overall length of the tube from where in meets with the Trans casing to where the shaft comes out of it.
2) from the surface where the pivot arm clips on (where the clip comes thru the holes on that flat surface or where the slave cylinder comes through the bellhousing) to where the shaft comes out of the tube (end of the tube).
3) from the mounting surface on the bellhousing to where the shaft comes out of the tube.

transmission has been sold for a week, what were these measurements for?

[Chrisv006]

PM'ed

[bben76]

PM'ed about Brembo rotors...

[SK20iPPY PB]

If ICV works its mine. Hold the order for a moment while I compose a list of more parts.

[ethirtydavid]

PM's replied
ICV works - PM me with more questions / parts