SOLD - RX7 big brake kit $250 obo shipped

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • djjerme
    R3V Elite
    • Sep 2010
    • 5082

    #1

    SOLD - RX7 big brake kit $250 obo shipped

    SOLD SOLD!

    Includes:

    Brackets
    Calipers
    fittings to use with stock E30 hoses
    New pads (Hawk Blues - p/n HB155 9012)
    Machined rotors (these are VW Corrado G60 rotors milled out from 65mm to 66mm)

    Boxed up and ready to go!

    Had this question asked:
    "I'm interested in the BBK setup but have a few questions. Why did you end up deciding to sell? Where did you source the calipers? Can you confirm that they are in good condition (both inside and out)? Also, as far as hardware goes, everything is included to bolt these on, connect up factory style break lines, and get on the road, correct?

    This setup actually came on a car that we purchased, and had factory lines hooked up to and ready to go. It was a shell when we bought, so they had not put any hours on the rotors or pads. We checked the hydraulics when we pushed the car around the shop, and the calipers checked out fine.

    Outside that, it is ready to go. Like I said, we removed it, boxed it up. So you should just be able to unbox it, bolt it up and go.

    The reason we are not running it?

    Because we have a Ground Control setup that we are already planning on using and it uses a later, 5 lug setup. The other race cars we have must remain stock per class rules, so can not use this setup.

    Sent from my 710C using Tapatalk
    Last edited by djjerme; 03-21-2016, 09:51 AM.
    1991 325i MT2 Touring (JDM bro)
    2016 Ford Flex
    2011 Audi A3 - wife's other German car
  • HollywoodDale187
    Member
    • Oct 2015
    • 65

    #2
    Ughhhhh why does my bank account have to be not full.....

    Comment

    • djjerme
      R3V Elite
      • Sep 2010
      • 5082

      #3
      bump
      1991 325i MT2 Touring (JDM bro)
      2016 Ford Flex
      2011 Audi A3 - wife's other German car

      Comment

      • astrotraveller12
        Noobie
        • Jul 2015
        • 33

        #4
        I assume this is for just the front? Not the rears also?

        Sent from my GT-I9505 using Tapatalk

        Comment

        • djjerme
          R3V Elite
          • Sep 2010
          • 5082

          #5
          Yes.

          Sent from my 710C using Tapatalk
          1991 325i MT2 Touring (JDM bro)
          2016 Ford Flex
          2011 Audi A3 - wife's other German car

          Comment

          • peteWine
            Noobie
            • Aug 2011
            • 16

            #6
            Rotors balance out okay? Hub bores look not so round.

            Comment

            • djjerme
              R3V Elite
              • Sep 2010
              • 5082

              #7
              This setup wasn't actually ran on a car yet. But yes, the rotors were check to verify if there were out of balance, and they were fine. I can see if there is a spare hub lying around and I can get a photo of the rotors on an e30 hub.

              I do have this parallel listed on an auction site too, but will gladly cancel it for r3v member preference:

              1991 325i MT2 Touring (JDM bro)
              2016 Ford Flex
              2011 Audi A3 - wife's other German car

              Comment

              • 89alpina.i
                Member
                • Nov 2014
                • 42

                #8
                How much without the Rotors? I'd be 100x more comfortable having a shop bore some rotors instead.

                Comment

                • djjerme
                  R3V Elite
                  • Sep 2010
                  • 5082

                  #9
                  I dunno rotors are cheap.

                  $275 shipped?

                  PM me if you are serious about it.
                  1991 325i MT2 Touring (JDM bro)
                  2016 Ford Flex
                  2011 Audi A3 - wife's other German car

                  Comment

                  • djjerme
                    R3V Elite
                    • Sep 2010
                    • 5082

                    #10
                    Bump for low, low price~
                    1991 325i MT2 Touring (JDM bro)
                    2016 Ford Flex
                    2011 Audi A3 - wife's other German car

                    Comment

                    • djjerme
                      R3V Elite
                      • Sep 2010
                      • 5082

                      #11
                      Sold!
                      Last edited by djjerme; 03-21-2016, 06:26 PM.
                      1991 325i MT2 Touring (JDM bro)
                      2016 Ford Flex
                      2011 Audi A3 - wife's other German car

                      Comment

                      • Reyhan335
                        Mod Crazy
                        • Nov 2015
                        • 700

                        #12
                        ugh and i just spent 350 on the same damns settup
                        e30Ls1 Swap IG: 1dirty30

                        Comment

                        Working...