FS: Lots of M10 Parts

[SoopaGhetto]

Sellilng off a lot of things that i have been collecting. Its been sitting in my storage/garage and i know someone could use these!

First off i have:
(1) 3.64 non lsd good condition. no whine. didnt leak on me. very dirty though. (i was gonna keep it and weld it but blah)










(1) cap
(1) rotor
(1) set of wires 8mm
(1) distributor [cap and rotor were bought together and are almost brand new (used < month) wires prolly a few months distributor prolly original BUT with older distributor gear]















(1) Crank Pulley



(1) fan clutch (nvr over heated bc of fan)




(2) distributor housings with pressure switch attached




(1) JETRONIC ECU along with some wire harness and idle control unit




(1) single chain cam sprocket




(1) cold start injector/idle air intake



(4) stock 14lb injectors
(2) rocker shafts
(1) end cam retainer
(1) used chain 170k
( 8 ) rocker with BMW 85 8.2 castings on all of them
(3) cam oilers with 1 missing a holder
(2) timing chain piston
(2) front cam sprocket cover
(3) TPS (2 m10 1 m20)






( 8 ) valve springs
(3) cast retainers




(1) Stock air box non swiss cheezed
(2) m10 AFM (1 untouched 1 touched)
(1) merkur AFM?
(1) set of suzuki gsxr 750 injectors/fuel rail



(1) set of mechanical injector with lines








Summary:

(1) 3.64 non lsd good condition. no whine. didnt leak on me. very dirty though. (i was gonna keep it and weld it but blah) - 50 + shipping
(1) Crank Pulley - 20 + shipping
(1) cap
(1) rotor
(1) set of wires 8mm
(1) distributor [cap and rotor were bought together and are almost brand new (used < month) wires prolly a few months distributor prolly original BUT with older distributor gear**]

cap + rotor + set of wires -> 30 + shipping
cap + rotor + set of wires + distributor -> 40 + shipping

(1) single chain cam sprocket - 30 + shipping
(1) fan clutch (nvr over heated bc of fan) - 20 + shipping
(2) distributor housings with pressure switch attached - 20 each + shipping
(1) JETRONIC ECU along with some wire harness and idle control unit - 60 + shipping
(1) cold start injector/idle air intake - 20 + shipping
(4) stock 14lb injectors - 30 + shipping
(2) rocker shafts - 20 + shipping (for both)
(1) end cam retainer - 10 + shipping
(1) used chain 170k - make offer + shipping
( 8 ) rocker with BMW 85 8.2 castings on all of them - 100 shipped
(3) cam oilers with 1 missing a holder - 15 each + shipping
(2) timing chain piston - 10 each + shipping
(2) front cam sprocket cover - 15 each + shipping
(3) TPS (2 m10 1 m20) - 20 each + shipping
( 8 ) stock valve springs - make offer + shipping
(3) cast retainers
(1) Stock air box non swiss cheezed - 35 + shipping
(2) m10 AFM (1 untouched 1 touched) - 40 each + shipping
(1) merkur AFM?
(1) set of suzuki gsxr 750 injectors/fuel rail - make offer
(1) set of mechanical injector with lines - make offer

**i used the distributor gear out of a 2002 so that i could use a 2002 schrick cam with stock distributor

****Also note i ahve (2) stock cam shafts in 'ok' condition. some the lobes has some surface rust and one of the shaft has a weird looking scar but not deep - want pics/make offer


i take paypal / any questions just ask

i would rather trade some things bc i need a transmission for my m10

[SoopaGhetto]

up

[Jean]

I'll take the fan clutch.

Is the AFM and known good, no dead spots? My car has a hesitation spot between 2500-3500rpm and I think it might be AFM as everything else has been replaced.

[SoopaGhetto]

I'll take the fan clutch.

Is the AFM and known good, no dead spots? My car has a hesitation spot between 2500-3500rpm and I think it might be AFM as everything else has been replaced.

yea they are both good. i have one that is original to the car, then i decided to get another one bc i was going turbo and thought it would be good to have one i could mess with.

the one i bought has had the tension spring adjusted. and the one original to my car nvr had the cap thingy removed. last time i used both 1.5 yrs ago they were fine to my knowledge

[Jean]

Where do I send the $, I'll take the fan clutch for now and i'll get back to you on the AFM.

[SoopaGhetto]

you can send paypal to rccuffee [a t] vt [d o t] edu

pm/aim me and we can finish the transaction

[Jean]

you can send paypal to rccuffee [a t] vt [d o t] edu

pm/aim me and we can finish the transaction

pm sent

[SoopaGhetto]

replied

[Jean]

payment sent, thanks!

[SoopaGhetto]

up

[SoopaGhetto]

up