Crosshair plates for "Smoked ellipsoid" mod

[compression]

Why aluminum and not thin steel?

Aluminum is better.

[Van Westervelt]

Why aluminum and not thin steel?

[compression]

OK, the order has been placed. No more PM's.
I ordered a couple extra sets, so there might be some left over.
If , in the future, there is a lot of demand for these, I will get another batch cut for you guys, but there has to be at least 10-15 people committed.

I am expecting to receive the parts early next week and I will post an update . At that time, payments will be due. I will PM everyone involved with the details.
thanks!

[n2motorsports]

im in too... pm on the way!

[Huff]

I'm in.. PM sent

[compression]

So you all probably know about the thread on how to convert your E30 ellipsoid headlights to the "smoked" look.
If you dont, here is a link to the thread:

http://www.r3vlimited.com/board/showthread.php?t=94540

"smoking" the high beam requires you to cut out intricate baffles out of a thin metal to form the "cross". The thread links to a template that you use as a cutting guide. This is a major pain in the a$s. I tried a bandsaw, hand shears, and a dremel, nothing gave me good results and were WAY TOO time consuming.

So, I converted the template to an Autocad drawing, which now allows me to have these laser or waterjet cut. This is the way to do it because they will turn out ultra-precise, and I wont have to spend 2 hours in front of a bandsaw.

I am getting ready to place an order for the baffles for my headlights and thought I would ask if anyone else would be interested in getting a set. I will be getting them cut out of thin aluminum.
For a complete set of baffles, it will be $30 shipped.
PM me if you are interested in getting a set. I want to place the order soon, so act fast.
thanks