If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yuppers...except your 10" sub is actually a 12, so that might be some hassle.
I can get a normal 10 and 2) 3" ports through the ski boot...but 2) 3" ports are actually a bit big for a normal 10. We are gonna build with 2) 2" ports first, then see what it sounds like.
I don't follow how my 10 is actually a 12, but I trust you so do whatever you want.
Luke, what size is the sealed 10? Can I get a thin sealed 10?
Patrick, I have no clue how the "Zen" edition is gonna work out. Next week, I am gonna get hold of a car with the Zen brace installed in it, and get some careful measurements.
Hopefully, there is enough space to get this to fit, just don't know.
The ported 10" box (largest 10" box) is only 4" at the top...as in, 15" from the floor, the box is only 4" deep, measured from the vertical braces.
How will the 10" perform behind m3 seats if the ports fire into them?
The car we are doing first has a normal late model seat, as in full foam padding. We are gonna cut out about 3" of padding, so it will basically be that same (or just a bit thicker) than the M3 seat.
Since 100% of the bass is sealed into the cab, ports and all, it should just rock. Cannot quite tell from here, though. I just don't do guessing well. I like to know from firsthand experience!
I can tell you this...that box is nice and small. Hit up JParker, he has the prototype in his trunk right now, only partially finished.
Just about done on the legal battles that are keeping me from this stuff. I am gonna pick up some more 8" subs on my way back North, but need to get back to work so I don't lose my job.
Shirkit Shitty closing down means a whole fucking BUNCH of shitty installers looking for work, I don't wanna lost my job right now...paid insurance FTW!
Soon, guys, soon.
PayPal is setup, gonna start hitting a couple of guys up soon.
Yuppers...except your 10" sub is actually a 12, so that might be some hassle.
I can get a normal 10 and 2) 3" ports through the ski boot...but 2) 3" ports are actually a bit big for a normal 10. We are gonna build with 2) 2" ports first, then see what it sounds like.
I used to do a lot of single 8" boxes with a single 4" port...I sure did like that, so maybe 2) 3" will work out well.
Patrick, the thin box is still awaiting developent. I will he hooking up with a car that has one installed when I get back home, early next week.
oh man thats so cool its all going through the ski hole. For some reason that didn't register when we were on the phone. I do recall you saying everything through the ski hole however.
If I understand correctly, the 10" V2 box is ported with port location being in-between the two rear speakers? (I want to keep rears) This is the one I want.
Paypal is ready too.
No, on the 10" box the ports are through the ski boot with the woofer, so no cutting is required at all.
We are doing JParkers car first. We will take photos and show how to ventilate the rear seat for the best "bang for the buck".
If I understand correctly, the 10" V2 box is ported with port location being in-between the two rear speakers? (I want to keep rears) This is the one I want.
Leave a comment: