Here's my wiring question: Pin 2 of the X6001 is the "Start signal" that comes from the car access module.
The S54 swaps have a similar pin and the explanation is as follows "6. Starting signal [ wire this to pin 18 on X20 it signals dme that engine is cranking]"
This makes absolutely no sense to me as the motor know it's starting from crank sensor signaling rotation.
Is this only related to "convenience start" or is it actually required?
The S54 swaps have a similar pin and the explanation is as follows "6. Starting signal [ wire this to pin 18 on X20 it signals dme that engine is cranking]"
This makes absolutely no sense to me as the motor know it's starting from crank sensor signaling rotation.
Is this only related to "convenience start" or is it actually required?
Comment