My m50 swap

[ahriley91]

Welp...just found out what wire was cut then. Fantastic. Thanks for all your help Wh33lhop. Seriously.

[Wh33lhop]

There should be an O2 sensor plug. It's held by a little bracket just below the starter:

[ahriley91]

So not much to update. I got to the point where I tried to crank it, found out that a m42 starter doesn't want to turn an m50 over, stupid me, and I am now looking for a m20 starter, single mass flywheel, clutch, pressure plate, and euro 323i throwout bearing. Will be an upgrade anyway. If anybody knows where I can get those for cheap, that would be great.

It would also apear that my 11/95 e34 525i touring auto wiring harness has no spot on it for an o2 sensor. Am I just a tard? Looking on realoem, I don't see any spot for it on the wiring harness. Help?

[dr.gonzo]

Me too, Just trying to find the right m50

[619E30]

Nice swap. Planning on doing the same to my 90 325i

[ahriley91]

Update!!

So today my buddy Stevo and I got an early start to the day. We went to the junk yard and that was completely unsuccessful in finding the brake booster and master cylinder. I had a booster, it was just the wrong one. Awesome for me. We then went and got my intake manifold. Then we went to pep boys or something and got all of my fluids and got some taco's and the taco bus. Best place ever. By far one of the most authentic Mexican food...in Washington. I'm sure there are more authentic places somewhere south? Anyway...We got back to my house and went straight to work on getting the tranny onto the engine. We then spent the next 2 ish or more hours figuring out how to put the engine and tranny into the car. And then...success!!!! I now have a m50 in my e30. I am more then stoked. But...and there is always a but...I hate the mess underneath the intake manifold. I am thoroughly confused on how it all goes back together because I didn't take it apart. If I take it apart, I can put it back together. So I will post more pictures of the mess and all the help from you guys would be GREATLY appreciated. So...on to the pics of the day. Funny pic of me drinkin sunny d. Love that stuff.

[ahriley91]

It is gettin done. I'm droppin the engine in this weekend so the next major update should be a little more exciting then me asking questions. haha

[Wh33lhop]

No worries. Git 'er dun.

[ahriley91]

I've got an e34 wiring harness. And my battery is in the trunk. Thanks a lot. I was pretty sure that I had everything that I needed. Dumb moment for me. haha

[Wh33lhop]

I feel super dumb right now. So now that I have the new wiring harness, how do I keep the battery in the trunk? Is there some more wiring that I need to do to do this? Any help is greatly appreciated.

Huh? The harness should accommodate the trunk battery fine. Your car has the battery in the trunk, does it not? You're good to go. The big starter wire goes to the big positive terminal, then bolt stuff up normally. There's probably a good size ground wire or two that goes to the ground post on the strut tower. I had an E34 harness so I only had one ground wire, if you've got an E36 harness I'm not sure if you've got one or two.

[xwill112x]

I will post it. I just stumbled across it and freaked out because it was the perfect one for me. Here it is.

[ATTACH]26995[/ATTACH]

does anyone have something like this for a 91 318i and a 92 e34 nvm50?

[ahriley91]

Anybody? I will search some more but if anybody could tell me, that'd be great.

[ahriley91]

I feel super dumb right now. So now that I have the new wiring harness, how do I keep the battery in the trunk? Is there some more wiring that I need to do to do this? Any help is greatly appreciated.

[ahriley91]

I will post it. I just stumbled across it and freaked out because it was the perfect one for me. Here it is.

[johneod75]

Where did you find the diagram?

http://wedophones.com/BMWManualsLead.htm