S52 OBD1 Swap no start/no fuel
Hi, I just finished getting everything all wired up and sorted out on my s52 swap into my e36, I know this is an e30 forum and all but honestly I've had more help from all of the e30 guys than any e36 forum I think most of them are brain dead or just not helpful at all.. But anyways I just got everything hooked up on my car all the wiring was label and installed corrected to my knowledge. I turned the key on, here a relay click but there is no fuel pump and my check engine light comes on but doesn't go off. I checked the codes to see if it was throwing any and it just flashings one short time and one long time then it restarts all over again and there isn't any OBD1 codes that it goes too. This harness, dme, and all of the relays all came from a running car. I am running a 413 Red Label ECU with a chip, 540 HFM, 21.5lb/s injectors, headers. I have checked all of the grounds even tried grounding the ecu. All the sensors are all brand new oem sensors as well.
Any help would be greatly appreciated! Thank you guys!
Any help would be greatly appreciated! Thank you guys!