Announcement

Collapse
No announcement yet.

Oil level sensor connector

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Oil level sensor connector

    So my s52 wiring harness didn't include an oil level sensor 3 prong connnector. Do you guys know where I can buy one and how I should wire it into my harness?

    #2
    You can chop off the oil level sensor off an E30 harness. Worked for me.

    I used this thread to help with the wiring.

    http://www.r3vlimited.com/board/showthread.php?t=143507

    Comment


      #3
      What if I don't have an e30 harness?

      Comment


        #4
        http://www.partsgeek.com/gbproducts/...FYc8aQodF60Avw


        Would this work for the oil sensor? Basically a three prong connector with three wires.

        Comment


          #5
          you could use a 3 prong weatherpack connector. that's what I did.
          '89 325i OBD2 S52 BUILD THREAD
          Shadetree30

          Comment


            #6
            If there is a parts yard nearby, go cut it off of a 5-series. I ran two new wires (the third I tied into the other grounds) through my S50 harness for an OEM look. Then I simply connected them to the correct E30 wires through the C101. I also added a couple new wires at the same time, again routing them through the C101, for oil temperature and pressure senders.

            Comment

            Working...
            X