Originally posted by Matt-B
View Post
Announcement
Collapse
No announcement yet.
The comprehensive DOHC engine swap thread.
Collapse
This is a sticky topic.
X
X
-
Originally posted by Matt-B View PostYea, I just need that fitting that goes from a small hose to big hose.
Thanks man, can I pick your brain tomorrow? Or come down and make some notes?Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
Comment
-
Originally posted by Matt-B View Postwant to look at your vacuum routing and etc and starter wires etc thanks buddy, call you about 10 or so AM
(Yes, I know alot of shit can be in the way, but who knows.)2008 335i - n54b30
1991 318i - m52b28
1994 fzj80 - LAND CRUSHER
Comment
-
the smaller bracket is designed for holding... Im not sure, but it goes between intake bracket and the small slot goes on the bottom fin of intake
One you see the 2nd pic, you can see it fits nice an snug in there
Other bracket, kinda the same deal, holds a heater hose i guess, but Mine wont reach
the end of the bracket shaped like this UU holds the fuels lines and need to be turned to make them run horizontal ish..
Hope that helps Josh, its cold outside
Comment
-
Aight, time for another round of "where does this go"? :D
1. Plugs into the valve cover, at the front near the end of the fuel rail.
2. Plugs into the inlet of the hose connector that's on the E34 dipstick, right?
3. ?
4. ?
Part II of #2: Where does the hose go that plugs into the other end of the hose connector on the dipstick?
Comment
Comment