Heckspoiler refinishing

[p0cket penguins]

if you want... ill refinish it for ya

[Aptyp]

that looks awesome, i'll send you mine to do this to it

[hootie]

nice write up. shit looks clean and smooth. NOW WE NEED SOME RIMS.

[p0cket penguins]

http://www.autogeek.net/wufltrpa.html

[lowlightbw]

thanks so much for the writeup!, where can you pick up the "flexible" trim primer??

[StereoInstaller1]

did you use a flexible trim primer

I think so.

[p0cket penguins]

did you use a flexible trim primer

[StereoInstaller1]

The GFs' lip had big cracks in it.

I sanded them completely out, filler primered, then repainted.

A year later, they are visible again.

Has anyone seen a fiberglass replica of the stock "is" lip?

[p0cket penguins]

My cracks were just cracks in the exterior finish

[thereisnoyun]

depends on the crack... if the crack is not just hair line cracks, and you still try to salvage the piece, itsis better to fill it with some kind of body filler then filler prime it.

[Desaevious]

Yup, only difference is I clear coated mine and painted outside.

[p0cket penguins]

Write up for refinishing an e30 heckspoiler

Tools
Masking tape
sand paper ranging from 180, 400, 600, 800, 1500 grit
2 cans Duplicolor Filler Primer
1 can wurte flexible trime paint (satin)
isopropyl alcohol

1. First remove the spoiler from under the trunk panel. This can be done with a 10 mm socket. Remove 6 plastic nuts

2. Take 180 grit sand paper and try to sand flat as many cracks and deformations as possible.

3. Clean the dust and grease off of the spoiler with a rag and isopropyl alcohol. Also make sure to mask the tag that says KTL Heckspoiler, cause thats just cool.
4. Hit it with filler primer about 5 coats. If you can still see the cracks when you apply the 3rd coat you can use the filler primer and spray the cracks directly, so that you fill them with primer. Dont worry about blotching we will take care of that later. Make sure to fill all the cracks with primer by the 5th coat.

5.Take a cup and fill it with warm water and a little bit of liquid soap. Then take little pieces of 400, 600, 800, and 1500 grit wet sand paper and sand it to a baby smooth surface. There should be no imperfections in the surface.

6. Then Clean the spoiler with a rag and isopropyl alcohol. Re Mask the label if needed. Then hit the spoiler with 3 nice coats of Wurth satin trim paint. Allow to dry for 12 hours or overnight and voila ... your ballin again



Thanks for reading,
Chris

[lowlightbw]

nice, im waiting to do mine. will be nice to see someone elses experience with it.

[p0cket penguins]

I should have a write up by tonight... for anyone that wanted to do this

[p0cket penguins]

oh man brilliant idea.... im gonna try that out tonight.... thanks man